tanca caixó 3

Rating:
  • Currently 0/5 stars.

Views: 244

Comment

You need to be a member of RhinoGold to add comments!

Join RhinoGold

Comment by pat schmidt on June 3, 2012 at 8:02am

or you can solder the hinge on ...either way...

Comment by pat schmidt on June 3, 2012 at 7:45am

yes ......

Comment by pat schmidt on May 19, 2012 at 11:57pm

not saying it can't be milled but..... hey here's the tutorial on making a hand made clasp and the finished one I made I made it in silver and gold plated it a long time ago!

Comment by pat schmidt on May 19, 2012 at 9:16pm

yes I have made them before including the hinge partby hand and on the mill.... I'll look up my file and send some pictures your way I also have a great tut on making a locket by hand...these are all exercises I did to add to my porfolio years ago.... and I do mean years ago before there even was a mill on the market! 

 found some old pictures..the tab on the top was a support I didn't cut off before taking the picture 

Comment by pat schmidt on May 19, 2012 at 8:56pm

I think it would be faster to buy a box clasp unless you needed it a 'special' size..a good exercise is to hand make it!..... I have a good tutorial for hand fabricating a box clasp I'll try and post the instructions ...you could not mill this....

RhinoGold, 3D jewelry design software | Time to adapt to new technologies | Don't get left behind & Happy Designing

Translate

Hello RhinoGold 5.0!


On February 2nd, RhinoGold 5.0!

Check all the news on www.rhinogold.com/v5

Happy Designing!

Notes

RhinoGold 5.0



RhinoGold Webinar Series: The best way to get familiar with RhinoGold



Here it comes a new way to see the new version RhinoGold 5.0 in live, to see how to create specific jewellery models, to understand the workflow of RhinoGold 5.0, to get the most from RhinoGold, and from your…

Continue

Created by Xavi Rofes Jan 29, 2015 at 3:53pm. Last updated by Xavi Rofes Jan 29.

© 2015   Created by Rafael del Molino.

Badges  |  Report an Issue  |  Terms of Service