Hola a todos! Alguien sabria decirme como podria hacer un colgante en forma de esfera, recubierta de letras sobre toda la superficie de la esfera. No quiero calar la esfera, sino que se vean las letras en relieve o que se vean como grabadas dentro de la esfera.

Gracias

Views: 396

Reply to This

Replies to This Discussion

I got the hola and the gracias part but that's about all

Sorry, is this the english forum? So my question was how to make a pendant with a sphere shape covered with letters and words on the whole surface of the sphere. Not trying to make a sphere with holes, but to write all kind of letters on the sphere?

Thanks

should be an easy one I'll post one later if no one else does

is this something like your trying to do?

OR...

Hello Pat;

Thank you that is exactly what I meant, so you start with a rectangle, write your words and letters on it and then you flow it by surface? Is that how you would do that?

Thank you soooooo much!

pat schmidt said:

is this something like your trying to do?

the 1st one was done using orient on surface....the second was done create uv crv then write ,then flow just did these as fast examples you could also try splop command ...but you have to practice these commands to see how they will work for your needs...let me know how it goes and theer is still another way to try it using project to srf then spliting the sphere away and offset the the letter surfaces solid... that's a total of 4 ways the fifth way would be to get fancy using cage edit...have fun with all..... I think I might have one more way but I didn't have time to try it yet

Thank you Pat,

I will try all this. Although I have spanish commands in my program, need firs to translate all.!!!!

Will let you know

Regards 

Béatrice
pat schmidt said:

the 1st one was done using orient on surface....the second was done create uv crv then write ,then flow just did these as fast examples you could also try splop command ...but you have to practice these commands to see how they will work for your needs...let me know how it goes and theer is still another way to try it using project to srf then spliting the sphere away and offset the the letter surfaces solid... that's a total of 4 ways the fifth way would be to get fancy using cage edit...have fun with all..... I think I might have one more way but I didn't have time to try it yet

are you trying to make a bead or a full sphere....

or...these are just some of the ways I would go about it I'm sure someone has a faster easier way they'd love to share so let's wait and see what else comes through maybe something better!

Thank you Pat, yes what I am trying to do is a sphere, not a bead, with a mix of letters covering the whole surface. My first idea was to put the letters engraved with a 0.6 mm profile in the sphere. But it can also be with a relief over the surface.

Regards

Béatrice

 well good luck and have fun!.... let me know how it goes.......

Reply to Discussion

RSS

RhinoGold, 3D jewelry design software | Time to adapt to new technologies | Don't get left behind & Happy Designing

Translate

One Day One Trick

RhinoGold Podcast! One of the best ways to learn RhinoGold! More...

Notes

RhinoGold News

Created by Xavi Rofes Aug 14, 2014 at 9:08am. Last updated by Rafael del Molino Sep 24.

© 2014   Created by Rafael del Molino.

Badges  |  Report an Issue  |  Terms of Service